buzzbomb
Well-Known Member
So for the last year iv been cleaning up my Double Eagle. So far iv put two brand new motors on it, new top,complete wiring, new dash gauges switchs and vhf. As of last week i picked up two Tempress helm seats and a new 7'' Raymarine Dragonfly sonar/gps. Now once i pulled the old back to back seats out i couldnt stop there because every thing has been installed new it was time for the vinyl on the floor and in the gunwales to go to. I was gonna look at putting new vinyl in but an leaning towards cleaning off the old glue and painting the gunwales with bilge kote and the floor with a marine non slip.The boat is almost new as its all been replaced including floor stringers and fuel tank just before i got it last year. Has any one ever been in this same spot with there boat, if so pros cons and products were used would be very appreciated. Like i said i got it striped and cleaned now its time to do right steps so the final finnish looks good and last. Thanks for any imput ill post picks when done.