ab1752
Crew Member
Ok so short of having a guy come out with a faro scanner, who can tell me how to measure the curve angle of the base of our boats windshield without removing it from the boat itself?
I need to submit a sketch of the frame base as it wraps around to the center of the boat (stupid euro frame anyway) as I want to confirm if pcmw can provide me with a suitable replacement without having to tool up? Tailor-made hasn't been of any help at all...a suitable plyable rod of about 8' would work but does that even exist? Then I would need to travel it out on a larger format sheet of paper which is doable.
Suggestions? Yes a pic better than this would help but you get the idea, it's just a typical curved Taylor Made setup.
Thanks guys.
I need to submit a sketch of the frame base as it wraps around to the center of the boat (stupid euro frame anyway) as I want to confirm if pcmw can provide me with a suitable replacement without having to tool up? Tailor-made hasn't been of any help at all...a suitable plyable rod of about 8' would work but does that even exist? Then I would need to travel it out on a larger format sheet of paper which is doable.
Suggestions? Yes a pic better than this would help but you get the idea, it's just a typical curved Taylor Made setup.
Thanks guys.