Corey_lax
Crew Member
I’ve sold my old motor and the new motor has a 25” leg. I’m going to weld a 1/4” aluminum piece on the back that will raise the transom 5” to suit the new motor. Most of the transom will be covered by this aluminum as shown in the one photo of a buddies boat.
I have lots of small holes in the transom from various transducer installs, speedometer, and the four large holes from the old motor mounting location. What would you do to fill these holes? Drill to fit 1/4” wood dowel and pound some dowel in with epoxy and sand flush? The holes will all be covered by the aluminum so they don’t have to be very aesthetically pleasing.
I have lots of small holes in the transom from various transducer installs, speedometer, and the four large holes from the old motor mounting location. What would you do to fill these holes? Drill to fit 1/4” wood dowel and pound some dowel in with epoxy and sand flush? The holes will all be covered by the aluminum so they don’t have to be very aesthetically pleasing.