So close to being done, then my steering cylinder decided I haven't spent enough money. Lots of clean-up of gelcoat and most likely going to do some better colour match on the gel coat, when I get time. Love the outboard rigging hose it cleaned up the transom.
I cleaned up the inside of my cuddy and boat with a garden hose last nite, there was fiberglass dust everywhere, hopefully the cuddy dries before I need to sleep in it.
First trip out since the revamped transom and love it! Having the full transom is great, safer and reduces noise from the engine. The new floor drains worked out well the only thing I disliked was having to put a thru hull on the side that is right at the waterline for the drain because that is how low the floor is and yes it is a stainless fitting with a scupper and shut off valve. However still think its a better to have the thru hull out the side than more holes in the transom. Anyone have suggestions to get my floor clean where I have fiberglass resin on my floor?? Scraping is ok but time consuming??
It's a splash
Great to hear, and on fathers day to boot.
Congrats on the repairs, and thanks for posting.
Don't know much about fiberglass but doesn't the resin break down under UV?
Might just let it sit in the sun for a few weeks and that might help.
After all this work letting the resin break down under the uv sounds great, gotta admit all the posts about fishing in Campbell and Kitty Coleman was my drive to get this done and thanks to everyone for their input on this thread. Now onto the L.E.D install(next week)!
That's a nice addition. Your going to love them. I like to be able to see what I'm doing in the wee hours of the morning heading out with out disturbing other boats around me. Oh yeah there cool too lol.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.