That’s some pretty good wear. Must be a hot marina.Been moored for approximately 60 days. Pulled at 1month, zincs all scrubbed. Is this normal wear? Still good enough for the rest of the season? New vs old.
View attachment 69282
Been moored for approximately 60 days. Pulled at 1month, zincs all scrubbed. Is this normal wear?
yeah that’s normal don’t worry. Lots of marinas eat zincs that fast. As long as you stay on top of it you’re fine.
I do them annually as well. I Find my trim tabs anodes wear out the most aside from the transom handle anode. And my trim tabs are grounded I believe (installed by Jenkins). I’m keen to switch to the disc shaped zincs that fit on the top & bottom of my trim tab instead of the rear. So just asking for what size to use & location is best to install those.Well first off id say your down to about 60 % so for a 1/2 year nothing to worry about, as I redo zincs every year and will say its doing a great job as I see it. now question is do you have zincs on trim tabs and are they bonded etc .
Use the size that it can fit and just put on top thats all you need if you put on bottom it wears off with water traveling under it.I use the bolt and tighten with the nut . then have a loop on my grounding wire and 2 flat washers and another nut tighten it all down. your good to goI’m keen to switch to the disc shaped zincs that fit on the top & bottom of my trim tab instead of the rear. So just asking for what size to use & location is best to install those.