SpringVelocity
Crew Member
The stainless (crap) plate on manual tilt broke. The arm/posts that engage and lock into the casted recess in clamping arms are sheared off. So I can't tilt it up anymore which really sucks.
Also the two casted clamping arms that lock into three positions on the two of them are sheared each side, so it makes motor hang on funny angle trimmed in.
So a few questions does anyone have a parts motor I can do a complete swap out?
If not has anyone had this happen? Short term I guess I can try and bungee it up a bit so it isn't dragging in water. What have you done?
Shops want like about 900-1000 with the labour and parts. Motor is not worth it. Just need short term solution before buying new one in the fall.
Also the two casted clamping arms that lock into three positions on the two of them are sheared each side, so it makes motor hang on funny angle trimmed in.
So a few questions does anyone have a parts motor I can do a complete swap out?
If not has anyone had this happen? Short term I guess I can try and bungee it up a bit so it isn't dragging in water. What have you done?
Shops want like about 900-1000 with the labour and parts. Motor is not worth it. Just need short term solution before buying new one in the fall.