trophywife
Crew Member
so i got my new motor installed in fall, runs great blah , blah, blah.... my concern and still have not got the FIRM answer i was looking for.
problem: when the motor is fully tilted, i still have 2-3" of leg sitting in the chuck.
my previous boat that did the same thing need a new bottom case after sitting like this for one season.
i have been told, "this is not a problem."
also,, lower the leg so the anodes contact the water. Why should i kill my anodes sooner than later?
and, lower the leg all the way down and leave it. (my boat is in the water dam near year round)
if it is bobbing in and out the water i will get even faster corrosion....
not pissed yet,, just confused...
DO I GET INSTALLER TO ADJUST FOR MY COMFORT OR?
problem: when the motor is fully tilted, i still have 2-3" of leg sitting in the chuck.
my previous boat that did the same thing need a new bottom case after sitting like this for one season.
i have been told, "this is not a problem."
also,, lower the leg so the anodes contact the water. Why should i kill my anodes sooner than later?
and, lower the leg all the way down and leave it. (my boat is in the water dam near year round)
if it is bobbing in and out the water i will get even faster corrosion....
not pissed yet,, just confused...
DO I GET INSTALLER TO ADJUST FOR MY COMFORT OR?