Lazy Bones
Member
I am converting my I/o to an outboard.
I cant determine if my numbers are good or not.
From the lowest point on my transom up to the waterline on my bottom paint is 22" vertically.
Most motors have 25" leg. That would leave me 3 inches above the water at the transom bracket ...
When doing the pod conversion, do we still want the engine's cavitation plate flush with the original keel and the extended keel of the pod?
Has anyone's pod build discussed these measurements?
I cant determine if my numbers are good or not.
From the lowest point on my transom up to the waterline on my bottom paint is 22" vertically.
Most motors have 25" leg. That would leave me 3 inches above the water at the transom bracket ...
When doing the pod conversion, do we still want the engine's cavitation plate flush with the original keel and the extended keel of the pod?
Has anyone's pod build discussed these measurements?
Last edited by a moderator: