New work on aluminum fuel tank?

Discussion in 'Boats, Motors, Trailers and Towing Rigs Forum' started by dkdivot28, Jan 21, 2018.

  1. dkdivot28

    dkdivot28 New Member

    Need new fuel pick up installed.
    Any good marine specialists near Nanaimo?

    thx
     
  2. ExFlyGuy

    ExFlyGuy Active Member

    Have you checked to see if the old one is just threaded in?

    If it is you can just unthread it and get a new one from the harbour chandler and cut it to size.

    If it’s welded in place that’s a different story.
     
  3. bigdogeh

    bigdogeh Well-Known Member

    I think some of them are just a thin plate flange with a rubber or cork gasket that's bolted or fastened with screws. Still fairly simple to install. As long as you have access to it.
     

Share This Page