stephennicholls531
Active Member
I spent some time dismantling/cleaning the parts from this low-time motor, and have almost all the parts available, from flywheel, starter, carbs, block, crankshaft, pistons, tilt/trim, gear case and almost everything in between. All parts have been properly cleaned, bolt holes have been chased/re-tapped and heli-coils installed where necessary.
Parts are all identified, ready to use, mating surfaces have been resurfaced, and where applicable, the required fasteners are included. Photos on request.
Most of these parts can be used on 115/130 HP Yamaha Two-Stroke motors from 1986 to 1994
I would prefer to sell the entire lot for $1200 OBO, but will also consider selling individual items.
Located in the Comox Valley.
Parts are all identified, ready to use, mating surfaces have been resurfaced, and where applicable, the required fasteners are included. Photos on request.
Most of these parts can be used on 115/130 HP Yamaha Two-Stroke motors from 1986 to 1994
I would prefer to sell the entire lot for $1200 OBO, but will also consider selling individual items.
Located in the Comox Valley.
