8hp yammy trim seal disassemble help

adrian1991

Well-Known Member
Any one taken one apart to change the dust/oil seal

Stumped on how to separate the cylinder rod end to gain access to the dust seal/nut
 

Attachments

  • 2020-06-10 15.25.48.jpg
    2020-06-10 15.25.48.jpg
    297.8 KB · Views: 23
What does the piston end look like? should be a fastener of some type loaded into the end of the shaft. Also a vise with aluminum soft jaws. Be careful not to score the shaft
 
The shaft might also thread into that piston. Vice with aluminum jaws, some heat, and using that small hole in the top of that piston try unwinding that from the shaft. Might be able to use a grinder chuck tool. Dont score the shaft or piston
 
Found a diagram looks like it's threaded on
Thanks for the input
 

Attachments

  • image_1.png
    image_1.png
    43.5 KB · Views: 13
Back
Top