Search results

Does it have the shift lever on the arm? I have a 2010 that needs parts. bullyjack@hotmail.ca

Thanks, just found the parts online. Listed under the steering section.

I have a 2010 9.9 yamaha, tiller with the shifter on the tiller. The cam that connects the shifter to the cable broke and its now stuck in gear. I think someone might have been messing with it in storage, wasn’t like that when i parked it. I can’t seem to find the part onlineor even the shifter...

24’ searay, 383 stroker bravo3 dualprop. Ran 34 miles, burned 78 litres at 32mph.

Little devils grafics in mission. They are in the back of the tool store by the casino.

Looking for a decent suspension/shock seat for the wife. Would like on with armrests. Her back is wrecked so if there’s any chop i gotta throttle right down, any recomendations on where to get one? Thanks.

Interested in the doghouse.

Has trim switch. New ignition with keys on amazon for 45$

I have yamaha throttle/shift controls, no key. 60$

They do boat top repairs?

Didn’t know chilliwack lake had a size restriction. Havn’t been there fo almost 20 years,guess my 24’ srv is a bit big.

Yup thats what i’m going to do, thanks.

Anyone know what the piece is that faces towards the front of the engine and has a rubber cap on it to block it off? It threads into the riser and has a barbed opposite end. The rubber caps are cracked and need replacing.

24’srv. 383, bravo3 dualprop 23 pitch. 46mph

Sold.

Merc 470, rebuilt pre alpha leg, trim tabs, small cuddy, runs everything works. Was told the floor was rebuilt and a larger fuel tank put in but has a soft spot in the center between the seats. Floor is fiberglass with vynal over top. Need batteries, buildge pump and blower. Trailer is aluminum...

Anyone know who or where they were made? Picked up a 18 1/2 ft with a hardtop.

Had em on every truck i’ve owned, best investment you can do.

Back then the welding machines didn’t have the teknolegy they do now. Now with being able to adjust ac balance, cleaning, pulse its alot easeyier to weld thinner material without distorting.

18 gallon, 12 1/2” high, 16” wide , 30” long. Comes with new filler hose and neck. Full of 50:1 2 stroke mix, askin 100$.was mounted under the outboard well on a 16 1/2’ boat.