I took the prop back to Sherwood, they exchanged it for another 4 blade with a different pitch. Sure enough it maked the same annoying noise. I trolled with it today for 4 hours and it seemed to get marginally better as the day went on. I will use a 3 blade if necessary but would much rather have a 4 blade for trolling. I'm debating on filing the trailing edge a bit as I've read that this can solve the problem.Get rid of the 4 bladed prop. I was told by the mechanic at Sheerwood Marine in Victoria that this was a problem that they had and only recomended the 3 bladed prop.
I ran into a guy at the marina with the exact same new motor and prop. He has the same problem. Took the motor to Sherwood and everything tested out fine. I think it depends on the boat design. Apparently boats with pods have this issue more then others so that could be the case. The crappy part is it only makes the noise right at a certain trolling rpm so it's hard to diagnose. I'm not ruling out that it's not the prop but figure it would be a good starting point before I have to bring the motor back to the dealer.I find it odd that it's the prop, mine does not do this and neither does a friends boat both running new 9.9s with the 4 blade as supplied.
Noluck has a good idea. The problem with trying to replicate an issue at a shop is that test tanks can run motors but cannot put the same load as a vessel in water. Have seen this a few times where issues do not show up in test tanks but a water test showed immediately.I ran into a guy at the marina with the exact same new motor and prop. He has the same problem. Took the motor to Sherwood and everything tested out fine. I think it depends on the boat design. Apparently boats with pods have this issue more then others so that could be the case. The crappy part is it only makes the noise right at a certain trolling rpm so it's hard to diagnose. I'm not ruling out that it's not the prop but figure it would be a good starting point before I have to bring the motor back to the dealer.
Yes it sounds more like a harmonic/pinging noise rather then squealing.so a strange harmonic?
why not identify the problem before fixing what might not be the problem.So I just spoke with the mechanic at Sherwood and he seems quite positive it's to do with the air intake. All I need to do is ream out a small hole a little bit, takes 5 minutes to do.
So I just spoke with the mechanic at Sherwood and he seems quite positive it's to do with the air intake. All I need to do is ream out a small hole a little bit, takes 5 minutes to do.