Reply With QuoteA rad shop wont have them. I'd look at a marine shop or google.
I am doing final assembly on my Sangster project boat. I notice one of the rubber caps for the heat exchanger looks a little suspect. Any one know where I would find such an item? A rad shop?
Alan
A rad shop wont have them. I'd look at a marine shop or google.
I think holmes grabbed my junk in the "pile on" though....I found it inappropriate but I was released gently; given what we were piling on about I found it educational as to a good release.~ Pip
And Lipripper - until you have been there, I would strongly suggest you STFU. ~ bigbruce
Hey Alan, is it for the San Juan Exchangers? The 165 hp 6 cyl. about 3" dia., which mounts vertical on the side of the engine, or is the 4" ones that mount horizontally across the front of the V6 - V8s?
I believe it is the San Juan system, it is 4" dia and mounted vertically to the starboard side of engine. I am going to call San Juan in Bellingham on Monday and see what I can do, perhaps they have a distributor this side of the border.
Alan
Alan give these guy's a call, as they may have one for you.
Island Radiator & Battery 498 Puntledge Rd
Courtenay, BC V9N 3R1, Canada
Phone: (250) 334-4932
"There are in fact two things , science and opinion,The former begets knowledge , the latter ignorance " Hippocrates
The Harper™ Government©: Winging it since 2006
Thanks GLG. I'll give them a call tomorrow.
Al
Get hold of me if they don't, I think I have a couple of extras.
That's the same as the motor I pulled out of "the unknown" hull.
So, how did you make out, did you find the ends you need?
Posting Permissions
