Motor price? Yamaha 2015 200hp 190 hours.

10 - 15k I would think maybe a bit more considering you would be giving the controls and gauges with it. ive seen rebuilt older units up for 10 - 12k before on craigs, you going to remove the command bridge? itll be a sick fishing boat if redone properly

https://vancouver.craigslist.ca/nvn/bpo/d/completely-reconditioned/6545908586.html

https://vancouver.craigslist.ca/rds/bpo/d/yamaha-twin-f200-4-strokes-3k/6517861985.html

https://nanaimo.craigslist.ca/bpo/d/april/6551535126.html

https://abbotsford.craigslist.ca/bpo/d/2012-yamahahours/6505967312.html

https://sunshine.craigslist.ca/bpo/d/yamaha/6509894590.html
 
Last edited:
I would say 12-15k for the motor, also depends if you trade it in or sell privately. Good luck, i was thinking about checking that out but I assume the stringers, floor and transom would have to be redone if they havent been already. Too big of a project for me!
 
not to deflate the balloon but That boat seems to sit a fair bit low in the stern, best check it real good for water intrusion or be prepared for a bunch of work.
not sure that 200 is the cause of it being so low
 
not to deflate the balloon but That boat seems to sit a fair bit low in the stern, best check it real good for water intrusion or be prepared for a bunch of work.
not sure that 200 is the cause of it being so low

I was thinking the exact same thing when I saw that photo. Good call.
 
not to deflate the balloon but That boat seems to sit a fair bit low in the stern, best check it real good for water intrusion or be prepared for a bunch of work.
not sure that 200 is the cause of it being so low
I was thinking the exact same thing when I saw that photo. Good call.

Thanks for the concern guys.

Like I said in my original post, if I get the boat the first thing I will be doing is gutting it. This will include removing floor and checking/ replacing stringers and Transom if necessary. Also a proper outboard bracket will be required.

Time will tell if I get the boat. We are heading up to Williams lake Thursday to take a look.
 
Thanks for the concern guys.

Like I said in my original post, if I get the boat the first thing I will be doing is gutting it. This will include removing floor and checking/ replacing stringers and Transom if necessary. Also a proper outboard bracket will be required.

Time will tell if I get the boat. We are heading up to Williams lake Thursday to take a look.

It's a long way from Williams Lake to Oliver...
 
Back
Top