Mine has quit working ,motor runs no lift. checked fluid ok. If I cycle switch it lifts a bit each time. Ideas please. Have taken off of motor going to take apart??Can't find much info on the net. any help greatly appreciated,, J R.
make sure the manual release is tight before doing anything. you say the motor runs but no lift action, fluid levels are check in the full up position. if the release is tight back it of and manually raise and lower the engine a few times. then tighten it up and try the hydro's
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.