motor only, not elec tilt, well maintained, serviced nov 6, can contact my mechanic. on boat and can be started if interested. campbell river. $1500 obo.
2012 9.9 remote, long shaft, high thrust, elec start, purchased and installed new from showroom at S&G marine Victoria in 2014. Used 4 seasons. Receipt and maintenance records available. Winterized and on boat can be started and run. Located in Campbell River. $1750
Pretty much had my fill of these digital devices. Only 2 wks. old on new high speed and counter failed. I know scotty outsources production but come on guys get it together. Maybe enough posts re: digital counters will wake them up. Last year another new high speed............3 counters. Also...
Any particular gas treatment users, beside stabilizer for winter? Reed, injector cleaner, types or brands. Guide buddy mentioned his mechanic commented on cleanliness of reeds in his 250 yam.
Used 1 season, High speed 60" swivel base and approx. 300ft #250 scotty braid. $500. Scotty prices increasing very soon! Located in Campbell River, shipping not included, no pay pal.
Thanks to Campbell River RCMP, local pawn shop, and Scotty downrigger registration program aiding in recovering my stolen riggers. Strongly advise you register riggers with scotty. Also anyone with missing riggers contact CR police if you have serial #s they have about 20 in their office.
2005-225 DF
Rebuilt with new block June 2009
Service records available with all replaced parts listed since new
2012-9.9 Electric start
Quicksilver dual binnacle control with tilt
Complete set up for dual motor operation
Prefer to sell as pair
$8000...
garmin gps map 182
has started dropping satellite connection. unplugging, rebooting, can get signal back but a bit frustrating. any one else with this model or similar problem.
Any update on the high speed riggers. Have heard of battery draining issues, for single battery boats.
Larger boats, dual batteries, any issues?
Can you inline a third battery, for riggers only?
installed cylinder seal kit. purged air. 2 person job. not a complicated procedure. maybe can answer some queries if anyone in the same situation. $110. for kit.
Bit of seapage coming out steering column. O ring kit approx. $75. Was thinking taking it apart, gauging rings and replace. Any feedback would be appreciated.
Been a long time since I've changed an impeller. Any useful hints would be greatly appreciated. Getting intermittent flow and very hot water. Have all tools, no prob removing leg to access imp. Thanks
Would appreciate any info. or sites re: battling outboard motor company for manufacture defect that showed up shortly after warranty period expired. Case in point, engine block is porous and completely showered outside of motor with salt and filled inside with saltwater completely destroying...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.